The second 2 bytes are a little-endian-encoded message ID. The first 2 bytes are a little-endian-encoded sender ID (which is normally specified when making the original request). Packet formatĪll ScreenLogic packets are sent with an 8-byte header. There are lots of available messages supported by ScreenLogic that the app doesn't support yet, but can be added pretty easily as needed. See screenlogic API reference.Īll communication with a ScreenLogic unit is done via TCP, so responses will come back in the order they were requested.

Once you've connected with connectAsync(), there are a number of methods available and corresponding events for when they've completed successfully.

Where password is the remote login password. init ( systemName, ipAddr, port, password ) // ipAddr and password as strings port as integer await client. See example.ts for an example of interfacing with the library. See the Wiki for information on migrating from v1 to v2. Tested with a Pentair ScreenLogic system on firmware versions 5.2 Build 736.0 Rel, 5.2 Build 738.0 Rel Local connections require a Pentair ScreenLogic device on the same network (a network which supports UDP broadcasts). If the passwords are different, any suggestions on how to reset the confpig password?Ĥ.This is a Node.JS module for interfacing with Pentair ScreenLogic systems over your local network or remotely through the Pentair dispatcher. If it is, any ideas why I can’t connect to the controller using the SLConfig app?Ĥ. Is the password for the SLConfig application the same as the password for Remote login to the user app?ģ. Has anyone had this problem where you can connect remotely but not locally to ScreenLogic?Ģ. I installed the SLconfig application on my iPad (the same one that successfully connects remotely to the ScreenLogic app), but can’t get it to connect to anything, either locally or remotely. So I have been trying to configure the interface but not having any luck. Our network is set up as 192.168.1.x with a 255.255.255.0 mask which might confuse the ScreenLogic which MIGHT be expecting a 255.255.0.0 mask. However my guess is that the IP subnet mask has been incorrectly configured on the interface. Since ScreenLogic remote login works well, I’m pretty sure that the interface is wired correctly and can communicate over the modem. Our pool guy and I have called Pentair support multiple times, but unfortunately the advice tends to verge on the absurd, with guidance like “The ScreenLogic Interface won’t work if you have 5GHz configured on your modem”.

We just had a new Pentair ScreenLogic system added to our existing pool system We can use ScreenLogic to connect remotely to the system but when trying to connect on the local network the app never gets past the ”Searching for system controller” message.

Pentair screenlogic remote connection